Power supply XPS-50-50 for X-ray tubes

Power supply XPS-50-50 for microfocus X-ray tubes

Control and Power Supply Unit for X-ray Tube Irradiator of up to 50 W Power

Applications:

- X-ray defectoscopy;

- X-ray structural analysis;

- X-ray spectral analysis;

Experimental physics

The unit is designed for power supply and control of 3-electrode x-ray tubes of TRM50-50–type x-ray tubes with grounded anode, high voltage (anode) supply to cathode and anode current control by the way of changing voltage on the control electrode x-ray tube.

All modes of operation are controlled manually – by push buttons on the control panel (microprocessor); or remotedly from PC – via RS-232 interface (software should be ordered separately). Running and pre-set values of anode voltage microfocus x-ray tube and current are shown on 3-digit indicator boards. Modes of operation of the unit are indicated by respective LED.

The unit for x-ray tubes is made in aluminum eurostandard case. On the back panel, there are outlets for connection of irradiator, remote control connector, fan, line inlet.

Technical parameters

1. X-ray tubes 3 – electrode, grounded anode, TRM50-50-type

2. Maximum power at tube anode, W ….………………………………….. 50

3. Anode voltage, adjustable,* kV …………….………………………….……….…. 5…50

4. Tube anode current, adjustable,* mA …………………………………….………. 0,01… 1,0

5. Temporary instability per 1 hr operation:

anode voltage, not more, % …………………………………………….… 0,1

anode current, not more, % …………………………………………….….0,1

6. Instability on line voltage fluctuations, % ………………………………………...0,03

7. Line voltage and frequency, V/Hz ………………………………….……..………220 +10/-15% /50-60

8. Line power consumption,* not more, W……………………………...……………85

9. Ambient temperature at normal humidity, С° ………..……………………...………+10…+35